Installation precautions for Programmable Switch Butterfly Valve

1. The working medium of the Programmable Switch Butterfly Valve should be clean and free of particulate impurities. The dirt and filters on the surface of the Programmable Switch Butterfly Valve internal parts need to be cleaned regularly.

2. When installing, the coil of the Programmable Switch Butterfly Valve should be upward and kept in a vertical position. The arrow or mark on the Programmable Switch Butterfly Valve should be consistent with the flow direction of the pipeline. It should not be installed in places with splashing or leaking water.
3. Before installing the Programmable Switch Butterfly Valve, the pipeline must be cleaned. It is recommended to install a filter in front of the valve and a Control Valve in the steam pipeline.
4. In the pipeline system, the diameter of the Programmable Switch Butterfly Valve installed on the branch should be smaller than the diameter of the main pipeline valve.
5. The Control Valve cannot be used in explosive hazardous places.
6. The Control Valve cannot be installed in the concave part of the pipeline to avoid the condensation of steam condensate, impurities, etc. in the Control Valve.
7. When the Programmable Switch Butterfly Valve fails, in order to isolate the Programmable Switch Butterfly Valve in time and ensure the normal operation of the system, it is better to install a bypass device.
8. If the pipeline rigidity of the Programmable Switch Butterfly Valve is insufficient, it is recommended to fix the pipeline in front of the valve with a bracket to prevent the Programmable Switch Butterfly Valve from causing vibration during operation.
9. Before installing the Programmable Switch Butterfly Valve, pay attention to the product label and read the instruction manual carefully to determine whether the product meets the use conditions.
10. A pressure gauge needs to be installed on the pipelines before and after the Programmable Switch Butterfly Valve to observe the pipeline pressure.